Ingredients
dried bean curd
pork belly
cooking oil
soy sauce
rock candy
flour
hot broth (or boiling water)
Steps
You'll want to start the preparation for this early. It can take a few hours for the bean curd to fully hydrate.
In a large bowl, soak the dried bean curd in water. While the bean curd is in dried form, avoid breaking it into smaller pieces for now, which will lead to small unusable shards.
When the bean curd softens a bit, cut the bean curd into smaller pieces.
Now let's clean the pork belly. Add a dash of baking flour and salt to the pork belly.
You can rub the flour and salt into the pork belly with a small amount of water.
Note the color of the discarded water after cleaning.
Now we're ready to cut.
Cut the pork belly into slices, each with a thin layer of meat, fat, and skin.
When the bean curd is fully hydrated, fully drain out the water. Make sure to fully squeeze out the water, so the bean curd is as dry as possible.
Set aside all of the ingredients in preparation for the stir fry, including your pork belly, bean curd, and rock candy.
We'll also need about 3 tbsp of soy sauce for later.
Heat up the wok on high heat. Add a small amount of cooking oil. You don't need too much since the pork belly will release oils and fats as well.
In a separate pot, start heating the broth. If you don't have broth, feel free to use water.
Use chopsticks to add the pork belly to the wok. Take care not to let any residual water go into the wok with the pork.
Stir fry by shaking the wok to shuffle the pork. Turn the heat to medium. As the pork belly cooks, it should also release oils and fats.
When one side is cooked/seared, use chopsticks to turn each piece over.
Once both sides are browned, we can start to add the other ingredients.
Add around 4 pieces of rock candy, which will slowly melt and coat the pork belly.
Once you've added the rock candy, you need to keep stirring. Otherwise it will burn. The stove heat should be medium to low at this point.
There's no rush to melt all of the rock candy, but you should notice some of it making it onto the pork.
Now slowly add the bean curd. Again, use chopsticks to make sure that no water drips into the wok.
Briefly stir fry.
Add 3 tbsp of soy sauce
Thoroughly stir it in.
On the side, you should have been heating up broth in a separate pot. Broth is best for deep flavors, but you can just use boiling water if you don't have broth. Add enough broth to just cover the meat and bean curd.
Turn the heat back to medium.
Cover and let it cook until done.
You can periodically stir the dish.
This is what it looks like when it's done cooking.
Serve on a plate. This dish goes really well with rice, especially if you pour some of the sauce over the rice.






























